GVRP between 2 Powerconnect Switches

I'm trying to set up GVRP between a Dell Powerconnect 3524P and a Dell Powerconnect 3548P.  My eventual goal is to do most of the VLAN configurations on the 3524P and have them propagate all throughout the network, with the 3548P as my test subject.

However, I cannot get GVRP to propagate any VLANs at all.

What I'd expect: Statically configure VLANs on one switch, and add them as tagged to the switch interconnect port, and see them show up on the other switch as dynamicGvrp VLANs.

My setup:

_3524P_

* RSTP enabled on device and on all ports

* GVRP enabled on device

* GVRP enabled on Port g3

Port(s)  GVRP-Status Registration Dynamic VLAN  Timers(milliseconds)
                                    Creation    Join      Leave      Leave All
-------- ----------- ------------ ------------  ----      -----      ---------
g3       Enabled     Normal       Enabled       200       600        10000

* Port G3 in Trunk mode, native VLAN 1, with added VLANs of 3,11-13

* VLANs 3,11-13 all added statically on this device

_3548P_

* RSTP enabled on device and all ports

* GVRP enabled on device

* GVRP enabled on port g4

Port(s)  GVRP-Status Registration Dynamic VLAN  Timers(milliseconds)
                                    Creation    Join      Leave      Leave All
-------- ----------- ------------ ------------  ----      -----      ---------
g4       Enabled     Normal       Enabled       200       600        10000

* Port g4 in Trunk mode, native VLAN 1

* No additional VLANs configured on the switch