Hi there,
I am trying to configure a LAG between a VRTX 10Gb switch and an X-series switch (using Dell 10Gb SFP+ cables) - I have tried both X4012 and X1052 but I have the same issue.
When 1 of the 2 SFP+ cables is plugged in, the LAG status is UP but current speed is blank on the VRTX powerconnect and unknown on the X-series. I wanted to try disabling auto negiotation at the LAG level as well as the port level but I dont get an option of 10Gb port speed.
The real issue comes when I plug in the 2nd SFP+ cable. Doing so causes the X-series switch to reboot (sometimes continuously until I perform a config reset).
Any ideas?